Which is better, single cylinder hydraulic cone crusher or multi-cylinder hydraulic cone crusher?

Dear users, thank you for your attention and support! Single-cylinder hydraulic cone crusher and multi

-cylinder hydraulic cone crusher represent the current advanced level of cone crusher, automation and

 intelligentization lead the market trend. There is no one better, in fact, each has its own characteristics! 

Which one is more suitable for you depends on your specific material conditions, detailed requirements

 for finished products and even budget, personal preference and other subjective and objective 

conditions. The following is a comparison between single-cylinder hydraulic cone crusher and multi-

cylinder hydraulic cone crusher in general, and we hope it can be a reference value for your equipment 

selection!

1. Structurally speaking, single-cylinder hydraulic cone crusher is simpler than multi-cylinder hydraulic 

cone crusher! The simpler the structure, the lower the failure rate, the simpler the maintenance.

2, single-cylinder hydraulic cone crusher S and H two series, especially the S series of cone liner angle is 

larger, the feed opening is very large, you can easily eat 50-60 centimeters of large materials, which is 

particularly useful in the primary jaw crusher model is larger, or raw materials itself is not very large 

when the maximum feed! For example, if a 1200×1500 jaw crusher has a large discharge, the cone 

crusher behind the jaw crusher must be considered as a medium-sized crusher with an S-series single-

cylinder hydraulic cone crusher, or else the other cone crusher will not be able to eat such a large 

amount of material, and if the jaw crusher is forced to adjust the discharge opening to a smaller size,

 it will not only reduce primary crushing output and increase the wear of the jaw plates, but also because

 of the uneven impact on the material, some of the large material will still be discharged. If you force the 

jaw crusher to adjust the discharge opening smaller, it will not only reduce the primary crushing output 

and increase the wear and tear of jaw plates, but also due to the uneven discharge from the jaw crusher, 

there will still be a part of large material affecting the cone crusher to affect the cone output and finished

 product! There is also a common situation, in some cases to ensure that the yield to choose a larger 

size of the jaw crusher is required before and after the jaw crusher vibrating feeder, cone crusher models

 are increased, thus significantly pushing up the cost of investment in the production line, then we can 

use a small number of jaw crusher with a small number of the S series of single-cylinder hydraulic cone

 crusher, the jaw crusher to let go of the fight, the S single-cylinder hydraulic cone crusher easily eat into

 the later with a compound cone crusher! The S series single-cylinder hydraulic cone crusher can easily 

eat in the jaw crusher, and then the composite cone crusher or multi-cylinder hydraulic cone crusher or

 H series single-cylinder hydraulic cone crusher can eat the return material, which not only reduces the

 investment cost of the production line effectively, but also has high content of fine grains in the finished

 product with excellent granularity! Furthermore, for example, when crushing pebbles, generally not 

many large materials of 20, 30, 30, 40 centimeters, then you can directly use the S series of single-cylinde

r hydraulic cone crusher without the need to use the jaw crusher + cone crusher two-stage crushing!