What are the maintenance points of mining ball mill?
Selection of materials and then good, technologically advanced equipment, in the actual production of failures will occur, do not worry about the occurrence of failures, as long as we are careful in the production of maintenance and maintenance of equipment, equipment can be more durable, the following look at the maintenance of mining ball mills what are usually the main points.
一、 Inspections in production
1, in the running state of the mining ball mill, to carefully check the parts of the bolts have no loosening, especially just installed on the liner bolts in the running process is very easy to loosening, so pay extra attention.
2, the lubrication of each component should be checked every 4 hours, in addition to checking the ball mill bonding surface with or without water leakage, oil leakage.
3, check the bearing temperature of the mining ball mill, if the bearing temperature is greater than 60 ℃, stop and repair immediately.
二、Problems to be aware of when lubricating
1, reducer, motor lubrication good or bad, on the ball mill's operating efficiency has a certain impact, so these parts of the lubrication should keep the lubricant clean!
The amount of oil injection should also meet the requirements.
2, for the replacement of parts, oil injection operation for one month, to drain immediately. For the replacement of lubricating oil containing impurities, to first clean the inner wall of the oil chamber, and then add new lubricating oil. When replacing the lubricating oil at a lower temperature, the lubricating oil should be heated to about 25℃ first.
三、Overhaul of spare parts
1, every six months, to tighten the bolts, on the wear of the lining plate replacement, check the pipeline has no water leakage, whether the valves can be opened normally. If faults are found in the process of maintenance, they should be repaired in time.
2, every year, to the drive shaft and motor shaft concentricity adjustment, in addition to checking whether the ball mill installation base surface is loose, if any to be reinforced in time, so as not to bring the production process does not have to affect.
Through the above analysis of everyone on the mining ball mill maintenance points are known, equipment quality is important, but in the production if the equipment is not diligently maintained and maintained, the quality of good is also useless, so in the production of equipment maintenance and maintenance is very important.