Vibration is a very common fault in the process of crushing equipment. In order to reduce the impact of this fault on crushing equipment, crushing equipment in the occurrence of vibration can be carried out the following measures.
The measure to avoid the vibration of crushing equipment is to keep the rotor in balance. If the vibration of the machine increases during the production process, it should be stopped to check the hammer wear.
If the wear of the hammer does not reach the wear limit, the edge should be changed or shifted to restore the balance of the rotor: if the wear of the hammer reaches the wear limit, it should be replaced immediately.
In order to keep the rotor of crushing equipment in balance, some measures must be taken during replacement. Generally, the replacement method of Hammer is all replacement method and part replacement method. Both replacement methods need to group the hammer according to the weight error.
The replacement method is to replace all the old hammers with a new set of hammers of the same mass, but the waste is relatively large and uneconomical. Part of the method is to replace some old hammers with a new set of hammers of similar mass. However, attention should be paid to the replacement method, which requires cross displacement replacement, which can extend the service life of crushing equipment.